Combine it with cards like Ingenuity Engine, Extruder, Deretti Scrap Savant or Arcbound Ravager and it'd be a grisly inclusion into any artifact-heavy setup
Weeping Angel You might think that a card with Weeping Angels art should have flying
The shafts I used were made for these O-rings (on amazon.ca): uxcell Silicone O-Ring, 18mm OD, 12mm ID, 3mm Width, VMQ Seal Rings Gasket, White, Pack of 10 MTG_Shuffler_Shaft_v2 are the re-designed shafts with grooves to hold o-rings (the amazon link above) - if you print these, then don't print the shafts in the card.shuffler.v3mrb-parts.3mf file (right click on them and uncheck printable) nor the card.shuffler.shaft.rubber-band.3mf file if you're using small rubber bands, print the card.shuffler.shaft.rubber-band.3mf file (resized from the previous model) lastly, the shafts in the card.shuffler.v3mrb-parts.3mf don't have a groove, and could be plasti-dipped or used with U-shaped seals that wrap around the disc I was more comfortable in Fusion360, so I used it for the redesigned shaft (o-ring variant)
Easy Prey is an excellent example of this, like Void Beckoner before it
Im not sure shes ready for more complex decks quite yet, though, but for now, these will do
